Caledonia, MI

Performed heating system tuneup. Inducer motor and blower motor amp draws all within proper specification. Tested system safeties and ignition components. Pulled and cleaned flame sensor. Gas pressures and temperature rise are within range. Tested condensate trap and drainage system. Verified the safety and integrity of the heat exchanger. System is operating properly at this time and is in overall good condition. Thank you for having us out!

Club member furnace tune up. When I arrived the furnace was on a 7 flash code. A limit circuit lockout. I reset the furnace and system fired up properly. I cleaned the flame sensor checked and replace filter, checked motor amps and everything else worked correctly. Furnace is extremely oversized for the home causing it to overheat. Did inform customer of this issue as well. Replaced water panel

Performed heating system tuneup. Both system inducer motors are failing. 2nd furnace collector box is cracked. Heat exchangers are very rusty, but I could not discern any visible failures at this time. Units are on borrowed time. May be about time to replace. Megan is going to wait until they completely break. Thank you for having us out!

I responded to a system not cooling issue in Caledonia, MI. Upon inspection, I found that a wire had become detached from the contact switch due to a loose spade connector. I crimped on a new connector, reattached the wire, and restored full operation. After testing, the system was cooling properly. The homeowner was informed, and the issue was resolved. Thank you for having us out!

Found faulty thermostat. Replaced thermostat with new sensi smart thermostat and sensors . System is working properly in both heat and cool will return to install sensor when they come in

Full System Replacement Replace furnace and air conditioning system including the following: Goodman Furnace, 96% efficient, 60,000 BTU, Single Stage Heating Furnace with fixed ECM Blower Motor Goodman Air Conditioner, Up to 13.4 SEER 2, 2 ton Inside- Furnace installed in a drain pan on 2" tall corner "feet" with isolator material on top to help alleviate any potential vibration noise Drain pan equipped with wet switch or drain pipe run to floor drain New return boot with external 1" filter rack with filter cover All new condensate drain pipe with clear, see through, serviceable drain trap with clean out brush(installed on evaporator coil) Install appliance connector on furnace vent, then re-connect vent pipe New copper line set with new control wire Tape all sheet metal joints we connect to with tin pressure tape Custom made sheet metal adapters from existing duct to new equipment Outside- New AC poly pad 3" tall per code regulation New outdoor condenser coil Charge AC system accord

We were out today for our 19.99 AC Tuneup special Performed air conditioning tuneup. Verified operation of indoor blower and inspected evaporator coil. Tested condensate drain system. Verified proper air flow and temperature differential across coil. Outdoor controls and motors all testing within proper manufacturer specifications. Service disconnect is in good condition and properly fused. Compressor amp draws are within range. Verified condition of outdoor coils. Refrigerant levels are proper at this time. System is in overall good condition. Installed surge protection on furnace to help protect sensitive electronic components. Thank you for having us out!

Ac check up. Noticed that the system is oversized and not cooling properly, provided options for properly sized systems

Arrived at a customer's home to provide AC maintenance. The unit was carefully inspected for any signs of wear and tear. There were no issues found with the system. Ready for warmer weather!